Your new kit will come with instructions and images included on the packaging. Here they are again in case you lose or throw them out.

Getting Started

1. Turn the tank upside-down and unscrew the steel cap (see more below).
2. Point and pour e-liquid into the tank. (see more below)
3. Screw the steel cap back onto the tank.
4. Screw the tank onto the battery. Make sure to hold the battery by the rotating voltage dial while screwing in the tank.
5. Do not over tighten parts, but ensure that all parts are securely assembled and snug.
6. Consecutively tap the touch sensor 5 times to turn on/off your battery. (see more below)
7. To use, touch the bottom sensor with your pinky finger while taking a puff. Release sensor when done puffing. Smile N vape on! (see more below)

Refilling e-liquid

When you have about 20% of e-liquid remaining (below the glass level) or you experience a slightly burnt taste, you will need to refill your tank with e-liquid.

1. With the mouthpiece facing downwards, unscrew and remove the tank base.
2. Aim the nozzle of your e-liquid dropper into the side of the tank. Gently pour liquid down the walls into the tank without over filling ensuring it does not go into the central shaft hole.
3. When filled, replace the base into place, nice rhymes huh!?! Then screw the tank onto the battery. Your touch is now ready for use!

Changing your atomizer coil head

Once you experience a burnt taste, a decrease in flavor or vapor production, it may be time to replace your atomizer head. It is recommended to change your atomizer head once every 1-2 weeks (depending on use). To get the truest flavor from your e-liquid, we also suggest changing your atomizer head when switching e-liquid flavors, especially after cinnamon, menthol or coffee flavors.

1. To replace the atomizer head, turn your tank upside-down with the mouthpiece facing downwards
2. Unscrew and remove the steel base.
3. While still holding onto the steel base, grip the top of the atomizer head and unscrew it counter clockwise to remove the atomizer head from the steel base.
4. Once the old atomizer has been removed, screw in a new atomizer head by turning it clockwise into the steel base until you feel resistance. Make sure not to over tighten the atomizer head as this may damage the rubber O-rings and cause leakage.
5. Screw the steel base back onto your tank by turning it clockwise. Make sure not to over tighten.
6. Wait a couple of minutes before using, allowing your atomiser to saturate. Or, Prime your atomizer by taking a few “dry puffs” without touching the power sensor.

Battery operations

- To turn on/off: Tap the touch sensor 5 consecutive times. To use, touch the bottom sensor with your pinky finger while taking a puff

- White LED light indicates 80%-100% charge, blue led light indicates 40%-80% charge, Red led light indicates under 40% charge remaining and it’s almost time to re charge

- Restrict sensor from direct contact with metals

- For your safety, the Touch battery has a cut off time upon 8 consecutive seconds of use

Charging battery

Remove the tank from the battery, screw the battery into the USB charger. You can charge through a computer USB port or via your wall adapter. Always ensure to be holding the battery by the voltage dial whenever screwing the battery into the charger or a tank. The indicator light on the battery will turn red when charging and will glow green when charging is complete. Allow 2.5-3 hours for the battery to complete charging.

Smile N Vape on!